Setups
Exchange model settings and discuss
| Subject | Views | Posts | Last post |
|---|---|---|---|
| Goosky S2 Max with Vbar Evo 8.2 translated by Jurrien Saelens | Views: 0 | Posts: 1 |
15 November 2026 19:4215.11.2026 19:42 by Jurrien Saelens |
| It flies translated by Master FBL | Views: 0 | Posts: 29 |
15 November 2026 19:2515.11.2026 19:25 by Master FBL |
| Tail Servo Type selection for the Theta TS-RTH1 Tail Servo translated by fdoehler | Views: 1 | Posts: 4 |
11 November 2026 14:2911.11.2026 14:29 by fdoehler |
| Tandem (Chinook) with 2 servos per swashplate translated by JMalberg | Views: 0 | Posts: 46 |
13 October 2026 16:4513.10.2026 16:45 by JMalberg |
| Rear adjustments EC 135 Vario Turbine translated by easy | Views: 0 | Posts: 5 |
16 September 2026 11:1516.09.2026 11:15 by easy |
| Tandem helicopter yaw control translated by Master FBL | Views: 0 | Posts: 7 |
15 August 2026 19:5415.08.2026 19:54 by Master FBL |
| Tandem helicopter general questions translated by Master FBL | Views: 0 | Posts: 7 |
28 July 2026 20:1128.07.2026 20:11 by Master FBL |
| Trex550/Vstabi/iX14 switching between idle ups translated by Mvanraak | Views: 0 | Posts: 4 |
22 June 2026 22:0722.06.2026 22:07 by RV |
| Pitch curves translated by Simon_75 | Views: 0 | Posts: 6 |
2 June 2026 16:0502.06.2026 16:05 by Simon_75 |
| VBar signal sent to Spektrum ESC. Motor not starting. translated by Helge-B | Views: 0 | Posts: 3 |
14 May 2026 19:0014.05.2026 19:00 by Helge-B |
| Help needed, heli just wants to roll over on lift off... translated by jamesf | Views: 0 | Posts: 26 |
20 April 2026 20:5520.04.2026 20:55 by RV |
| throttle calibration -> futaba radio + hobbywing esc + vbar neo translated by ReadyToFly | Views: 0 | Posts: 4 |
5 February 2026 09:0805.02.2026 09:08 by Eddi E. aus G. |
| Roban B412 800 Size Help translated by Nate_Dallas | Views: 0 | Posts: 13 |
22 October 2025 10:0722.10.2025 10:07 by Eddi E. aus G. |
| Neo - EVO? translated by Kjell | Views: 0 | Posts: 3 |
13 June 2025 20:0113.06.2025 20:01 by Kjell |
| Esc won't spool up motor translated by Kjell | Views: 0 | Posts: 10 |
26 May 2025 14:2826.05.2025 14:28 by Kjell |
| VBar RX-Only, 7-channel receiver translated by rutra | Views: 0 | Posts: 16 |
8 May 2025 11:2008.05.2025 11:20 by rutra |
| Alpina 3001 electric glider translated by Rainer2019 | Views: 0 | Posts: 13 |
25 February 2025 16:5525.02.2025 16:55 by Rainer2019 |
| Backwards Rolls Vs Forward Rolls translated by hibor | Views: 0 | Posts: 12 |
4 February 2025 09:2704.02.2025 09:27 by Eddi E. aus G. |
| Swash Plate End Point menu adjustment affects mid point translated by Jerry671 | Views: 0 | Posts: 5 |
28 December 2024 01:0028.12.2024 01:00 by Jerry671 |
| Hughes 500 - Thanks for the instructions translated by Dirtygeri | Views: 0 | Posts: 2 |
8 October 2024 21:3208.10.2024 21:32 by RV |
| Copy Mini Blueline setup to Vstabi Neo/Evo translated by Dirtygeri | Views: 0 | Posts: 4 |
26 August 2024 14:2926.08.2024 14:29 by Eddi E. aus G. |
| Sailor setup translated by Mani93 | Views: 0 | Posts: 1 |
25 May 2024 13:1325.05.2024 13:13 by Mani93 |
| Vbar Evo with Hott receiver translated by Lufur | Views: 0 | Posts: 4 |
29 February 2024 08:4929.02.2024 08:49 by Eddi E. aus G. |
| 5 leaf head translated by Sylphide | Views: 0 | Posts: 3 |
15 February 2024 14:0815.02.2024 14:08 by Volker Wahlen |
| Multi-head setup translated by Bob C | Views: 0 | Posts: 5 |
26 December 2023 16:5426.12.2023 16:54 by Bob C |