← Setups

VBar signal sent to Spektrum ESC. Motor not starting. translated

Public Talk › Setups · Started by Helge-B on 7 March 2026 09:4007.03.2026 09:40
Helge-B 7 March 2026 09:4007.03.2026 09:40
I would like to fly a Blade 235CP helicopter with a Vbar Neo Logo 200 or Vbar NEO Mini receiver.
How can I connect the Blade ESC to the VBAR and what settings do I need to adjust to make the motors run?
I've already spent quite some time on this but can't find a solution.
Thank you for the tip!
machine-translated from German · Show original
Eddi E. aus G. 9 March 2026 10:2209.03.2026 10:22
Good morning,

Prerequisite: VBasic Firmware (select via vstabi.info/devices, then update VBar e.g. via VBar Control Touch or EVO (or more cumbersome via computer)).

There you can select the presets for OMP M2, for example (New Setup), and then navigate through the rest from there.
Model Setup/Macro Cells/Input/Output Configuration: AUX 1 -> Spectrum (outputs spectrum protocol)
Model Setup/Macro Cells/Change Macro Cells: here you can adjust the 'channels' as needed by Blade Flight Control, but we're out of our depth there :-) you'll have to figure it out yourself.

Or remove everything foreign and wire the VBar directly as Express/Pro/Pro+Rescue, orienting it to the setup of the LOGO 200.

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
Helge-B 14 May 2026 19:0014.05.2026 19:00
Hi Eddi,
Thank you so much for your tips. I'll try them out and get back to you.
Regards, Helmut
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless