← Setups

throttle calibration -> futaba radio + hobbywing esc + vbar neo translated

Public Talk › Setups · Started by ReadyToFly on 15 February 2021 17:1015.02.2021 17:10
ReadyToFly 15 February 2021 17:1015.02.2021 17:10
Hello guys,

I'd like to run a Hobbywing 120a hv esc on vbar neo with a futaba radio. My goal is to run the vbar neo governor.

I'm having a hard time with the throttle calibration. I power on the radio, move the throttle stick up and turn the Esc on. At this point, I should hear the max. throttle confirmation beeps from the ESC, but nothing happens.

Could you guys, please, let me know how to proceed? I couldn't find anything on the web about this specific combination (futaba radio x vbar x hw).

Thanks a lot.
Eddi E. aus G. 15 February 2021 17:3915.02.2021 17:39
Hello RTF,

please check out the Gov. II panel, in Setup. There, you can check the box (persistent, so you can power-cycle the NEO), do your stick thing, then uncheck the box again. ESC must be connected to the ESC port, obviously. If in doubt, you can connect a servo there (or parallel, using a y-harness), so you have a visible pointer for the output to the ESC.

Careful—with the box checked, you have throttle on your collective stick, no questions asked.

And please mind that the collective curve in your radio might interfere, if it's not –100...+100.

Man, was it difficult, back in the day :-)

Kind regards

Eddi

Born to fly ...
forced to work.
johnahamelv 5 February 2026 02:3405.02.2026 02:34
Eddi E. aus G. Wrote:
-------------------------------------------------------
> Hello RTF,
>
> please check out the Gov. II panel, in Setup.


Hell Eddi,

Where in the VBC EVO radio would I find this "Gov. II panel"?
Eddi E. aus G. 5 February 2026 09:0805.02.2026 09:08
Hi John,

Setup, all the way down to Governor (obviously :-) ), Output Settings, amongst others.

Best,

Eddi

Born to fly ...
forced to work.
VStabi VStabi Pioneer of Flybarless