Spektrum DX8

The goal of this setup is to simulate a VBar Control as best as possible. So we don't use flight conditions in real - they are just for display. All switches are connected direct to a RX channel.

Due some hardware limitations of the TX - the rescue switch does not have the (no 3-way, but spring loaded needed) hover mode for beginners as with Vbar Control.

At least - you can dial in the setup with the pc software or with a VBar control. Using a Vbar Control - this will always be the master if connected. It will allow you (if both connected and correctly set up) at least crossover-buddyboxing!

Please note that we used 2 DSM-X Sats running at 11ms. Running at 22ms or using DSM2 will not allow you to assign AUX3 to the Trainer (Rescue). In this case - consult your TX manual how to get a useful output here.

DX_8

 

PC Setup

Spektrum1 Spektrum2

 

VBC Setup

00422_E700_Olaf 00423_E700_Olaf

 

Settings of the DX 8 - We use switches to get the functionality according to VBar Control. The flight conditions in TX must be assigned because we need the throttle curve for motor switch.

DSCN6978-s DSCN6979-s DSCN6980-s DSCN6981-s DSCN6982-s DSCN6983-s DSCN6984-s DSCN6985-s DSCN6986-s DSCN6987-sDSCN6988-s DSCN6989-s DSCN6990-s DSCN6991-s DSCN6992-s DSCN6993-s DSCN6994-s 

 

VStabi VStabi Pioneer of Flybarless