Preset for the MSH protos.
Setup: align swash servos D510, tail D520. (swash, 16mm, tail, first hole).
MSH flybarless conversion. Cables towards the main shaft.
mv0 is for 2500rpm.(hovering)
mv1 is for 2600rpm.(idle1)
For more rpm lower the tail gain a little bit.
13,2 degrees of collective and 11 cyclic.
Have fun!
Edited 1 time(s). Last edit at 11/22/2009 06:19PM by synx666. Attachments:
open | download - mv0.vbr (5.6 KB)
open | download - mv1.vbr (5.6 KB)
Setup: align swash servos D510, tail D520. (swash, 16mm, tail, first hole).
MSH flybarless conversion. Cables towards the main shaft.
mv0 is for 2500rpm.(hovering)
mv1 is for 2600rpm.(idle1)
For more rpm lower the tail gain a little bit.
13,2 degrees of collective and 11 cyclic.
Have fun!
Edited 1 time(s). Last edit at 11/22/2009 06:19PM by synx666. Attachments:
open | download - mv0.vbr (5.6 KB)
open | download - mv1.vbr (5.6 KB)