News

Important Technical Information for VBar Control Touch

4 December 2018
If tightened too much, the two lower screws holding the bottom of the case of your VBar Control Touch may apply strain to the backside of the display inside. This may lead to permanent damage to the display.

As an immediate measure, please loosen those two screws by 1-2 turns, and tighten them only so much until you feel a slight drag with just the finger tips working the tool.

As a permanent solution, please replace the existing M3x20 screws by M3x18 or put spacers below the socket head (1-2 mm or 1/32-1/16 in), to avoid accidental damage to the display.

Read more »

September 29th: Helicopter meeting in Böblingen

29 October 2018

poster.png (thumbnail) Mikado will be present at the helicopter meeting with team pilots and an information booth!

Raffle of Mikado products (VStabi NEO) during the helicopter meeting!

As in previous years, Mikado Model Helicopters will again participate in the meeting with an information stand, team pilots and a raffle.

Sign up, come along, and chat with the team pilots and developers. Read more »

Read more »

VControl Touch Update (Amendment)

22 September 2018

update_0.png (thumbnail)We have prepared a bigger Update for Your Radio. It contains lots of bugfixes and known issue fixes. The Update includes a firmware update as well, so your Radio will boot after the update is finished. The Patchlevel of the new Firmware is 400 Read more »

Read more »

New VBar Control Touch Cloud Service

16 August 2018

vbct_cloud.png (thumbnail)We greatly extended our Cloud Service for VBar Control. Check out the new Pages simply by clicking on the cloud here, or in the bottom left corner of the page you find the cloud in the section My V-Devices.

To use the cloud service, enable the cloud setting in your radio. The radio will start transmitting all status data to vstabi.info, but only if a network is available and you are not using your radio actively. So it will never disturb any of the normal use. Read more »

Read more »

Server migration completed

26 March 2018

It's done! Vstabi.info now runs from a server with 32x the memory, 12x the processing power, 15x the access speed of the mass storage, and 10x the network bandwidth. I think you can feel the difference ;-) Access is now also secured via SSL for your data security.

This takes into account the increased future use of the server, especially with the new VControl Touch, which has a built-in WiFi module, making the use of web services much easier and more convenient.

We hope you continue to enjoy our products, the website and the forum!

Read more »

VStabi VStabi Pioneer of Flybarless