← Logo 400 ... 690

Logo 600 (aluminum head) rotor head problems? translated

Mikado Model Helicopters › Logo 400 ... 690 · Started by maurice.krause on 20 March 2025 16:5020.03.2025 16:50
maurice.krause 20 March 2025 16:5020.03.2025 16:50
Hello everyone,

I installed a new crankshaft today (which I ordered directly from Mikado), and I noticed that the middle part of the head, where the V is, has about 1mm of vertical play. Is that supposed to be like that? I was honestly shocked.
The helicopter didn't crash; the rotor shaft was replaced because the original one supplied was extremely rough and almost rusted (sounds silly, but it's true).

Maybe I'm just overthinking it, but I find it strange.
I would be very happy to receive feedback on this.

Here's a link to a short film to give you a better idea:
https://www.youtube.com/shorts/IFB-Vhqa98A



Edited once. Last edited on 20.03.2025 at 16:51 by maurice.krause.
machine-translated from German · Show original
Eddi E. aus G. 21 March 2025 09:0621.03.2025 09:06
Hi,

possibly at the upper end of the tolerance (bore to screw), and the head also 'slides' particularly well onto the shaft, but in my opinion not critical.

Because: the head is held in place by the Jesus screw (to prevent rotation and ensure it can't move), and fixed by the clamp (which also secures the drive arms). However, these don't seem to be tightened (yet), otherwise nothing should be able to move.

I've noticed that too, with other models/heads as well, but once everything is tightened, it's quiet :-)

Superficial oxidation is also nothing unusual, similar to brake discs.
Unlike the brakes :-), it helps to oil the shaft occasionally (wipe it with a rag and a drop of oil).

—Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
maurice.krause 21 March 2025 09:0921.03.2025 09:09
Hi Eddi,

Thanks for the reply, I'll tighten everything later and see.

Greetings
Maurice
machine-translated from German · Show original
maurice.krause 7 April 2025 08:1107.04.2025 08:11
Hi everyone,

A small update for those who might have the same problem in the future: after installing a new rotor shaft and tightening the lever arms of the TS drive without the rotor head on the shaft, until the rotor head was already quite tight on the shaft, the problem was solved :-)

Greetings
Maurice
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless