← Logo 400 ... 690

Blade bearing shaft tail rotor Logo 480 extreme translated

Mikado Model Helicopters › Logo 400 ... 690 · Started by christoph123 on 17 November 2025 17:0417.11.2025 17:04
christoph123 17 November 2025 17:0417.11.2025 17:04
Hello everyone
Search the shop for spare part 3051.
This is the blade bearing shaft.
Tail rotor.
Unfortunately, I can't find it; the search function didn't return any results either.

Thanks for the info
Regards
machine-translated from German · Show original
Eddi E. aus G. 18 November 2025 09:0318.11.2025 09:03
Good morning,

The current hub is 04630, or the complete tail rotor is 04615.

If in doubt, I would take the complete tail rotor; I'm not sure what the differences are, and that way a) everything would be new, b) everything would be included, and c) it's probably cheaper overall than buying anything else separately.

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
Christoph68 18 November 2025 11:2618.11.2025 11:26
Hello,

Just a heads-up: if you use the 4630 hub, you'll also need to buy new bearings, because the hub diameter is 5 mm. The original L400/480 hub, part number 3051, was only 4 mm in diameter. Alternatively, you could check if another dealer has the 3051 in stock.

greeting

Christoph
machine-translated from German · Show original
Eddi E. aus G. 18 November 2025 11:3918.11.2025 11:39
Christoph helps Christoph, I like it :-)

Yes, that's it, 4 mm vs. 5 mm.
How quickly one forgets 1 mm :-)

I think screws and thrust washers were also discussed.

—Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
Christoph68 18 November 2025 12:0418.11.2025 12:04
Hello,

Yes, we help each other out. That's one of the purposes of a forum. Back to the topic: if I saw correctly, the thrust bearing is the same, but not the ball bearings and the spacer between the front ball bearing and the thrust bearing. The screw for attaching the blade holder is also stronger (M3 vs. M2.5), but the washer between the rear blade holder screw and the thrust bearing is omitted. Now all the details should be clear.


greeting

Christoph
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless