Zalo
15 February 2026 17:4315.02.2026 17:43
Hello, I'm having a problem with my V8.2 Logo 200. While the rear end stays put and doesn't wobble like its predecessor, it doesn't lock into place properly. In one direction, it stops and then corrects the rear end by a few centimeters. In the other direction, it "locks" very vaguely. I've tried the usual settings and even created a new setup, but unfortunately, without success. What setting am I missing?
Hallo, ich habe bei meinem V8.2 Logo 200 das Problem das das Heck zwar hält und nicht mehr zittert wie beim Vorgänger, allerdings Rastet es überhaupt nicht schön ein. In die eine Richtung stoppt er und korrigiert das Heck danach nochmal um ein paar Zentimeter. In die andere Richtung "rastet" es sehr schwammig ein. Ich habe die üblichen Parameter probiert, auch schon ein neues Setup erzeugt leider ohne erfolg. Welchen Parameter übersehe ich?
Eddi E. aus G.
16 February 2026 10:5116.02.2026 10:51
Good morning,
After you set up a new setup, did you also do a trim flight?
Please also compare (especially the tail) when you deliberately set the trim flight value for the tail to 0, against what the trim flight determines.
Then there's the torque increase (which can always be increased further), and of course the sensitivity (more is always better).
Nevertheless, a certain asymmetry is inherent in the nature of things.
I'll also ask some specialists to look into the question :-)
Grüßle
Eddi
Born to fly ...
forced to work.
Moin,
nachdem Du ein neues Setup gemacht hast, hast Du auch einen Trimmflug gemacht?
Vergleiche bitte auch mal (insbesondere das Heck), wenn Du den Trimmflug-Wert für das Heck bewusst auf 0 setzt, ggü. was der Trimmflug ermittelt.
Dann wäre da noch Drehmoment Erweit. (kann man gern noch erhöhen), und eben die Empfindlichkeit (mehr ist immer gut).
Eine Gewisse Asymmetrie liegt trotzdem in der Natur der Sache.
Ich setze aber auch mal noch Spezialisten auf die Frage an :-)
Grüßle
Eddi
Born to fly ...
forced to work.
HeliALEX
17 February 2026 16:1017.02.2026 16:10
Hello,
I have a couple of questions about the current situation:
- Is the setup currently 100% standard?
- What rear limits are set in the setup?
- Is it the same in all banks/speeds?
- What value is set for the Torque Extension?
Thanks and regards
Alex
Hallo,
ich habe ein Paar Fragen zur aktuellen Situation:
- Setup ist aktuell 100% Standard?
- Welche Heck Limits sind im Setup eingestellt?
- Ist er in allen Bänken/ Drehzahlen das gleiche?
- Welcher Wert für die Torque Extension ist eingestellt?
Danke und Gruß
Alex