← Cafe

Swinging/pendulum after leaf change translated

Public Talk › Cafe · Started by Simon_75 on 20 February 2026 18:1720.02.2026 18:17
Simon_75 20 February 2026 18:1720.02.2026 18:17
Hello everyone

I fly my Goblin 570 with the standard settings (circular flight/3D). Today I switched from 550 to 570 blades and started at 1600 revolutions per minute.
Unfortunately, the tail has started to oscillate slightly. I reduced the tail sensitivity from 76 to 70, but that didn't change anything. What could be causing this? The new MS blades fit quite tightly in the blade holders, but I was able to improve this by moving them around a lot.

Does anyone have any ideas? The 550s are 1st and 570 ms composite.

Hobbywing controller
6S 5000mAh
Scorpio 4025
Translation 9.39
Rear blades 95

PS: Yesterday I was riding backwards with the rear end coming towards me, and the rear end swung out sharply for a moment. I was still using the 550cc engine at 1900 RPM.

Thank you and greetings from Switzerland

Simon



Edited 1 time(s). Last edit at 02/20/2026 06:18PM by Simon_75.

machine-translated from German · Show original
Eddi E. aus G. 23 February 2026 09:4423.02.2026 09:44
Hi Simon,

I would start with the usual suspects, assuming nothing else has changed.
The resistance of the leaves in the leaf holders should be correct, not too tight, not too loose, but above all equally taut.
The tried and tested method of keeping the helicopter in knife-edge flight, so that the blades don't fold down, is usually a good approach.

Wheel alignment – take a close look, if in doubt try something (adjust a linkage slightly, see if it gets better or worse or if nothing changes at all), even if it already looks good...

Leaf center of gravity – weigh if a suitable tool is available, or try a strip of Magic Tape (insulating tape, approximately at the leaf center of gravity) on a leaf and compare.

Otherwise, the pendulum motion while floating can be treated quite well with the parameter pendulum suppression (open it up wide, try it out).

A high-frequency oscillation can also indicate excessive sensitivity at too high a speed, or that something is stiff, that there is a breakaway torque. Check if the sliding sleeve alone (and the linkage) moves freely enough, and (if you've been fiddling with the tail rotor :-) ) whether, for example, the thrust bearings are installed correctly, or if anything else is binding when you (tail rotor with hub removed) pull the blade grips apart and try to turn the hub.

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
Simon_75 23 February 2026 13:5023.02.2026 13:50
Hello Eddie
Thank you very much, I will check and tinker with everything.

One more question: can the values for adjusting be assigned to the potentiometers?

I saw a video about it, but it was a different version of vstabi.

Thanks for the quick feedback and best regards.

Simon
machine-translated from German · Show original
Eddi E. aus G. 23 February 2026 14:0423.02.2026 14:04
Hi,

With the "Link Parameters" app, you can link a selection of parameters to the sensors and also set the value range and the type of setting (absolute, relative).
Please also consider the "Lock Parameters" switch; this allows you to protect the function against accidental changes.

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless