← Cafe

OMP M2 V3 OFS with MIKADO Mini receiver translated

Public Talk › Cafe · Started by TRACON on 26 July 2026 20:1326.07.2026 20:13
TRACON 26 July 2026 20:1326.07.2026 20:13
Question for the MIKADO team:

If I connect the mini receiver to the OFS of the OMP M2, can I then also control/trigger the rescue function of the OFS?
I would like to use my VBC for control.

Thanks and regards

Andreas
machine-translated from German · Show original
thomas1130 26 July 2026 20:3326.07.2026 20:33
Yes :-)
machine-translated from German · Show original
TRACON 26 July 2026 20:4426.07.2026 20:44
Great, thanks Thomas!
Then I'll order the receiver immediately!
machine-translated from German · Show original
TRACON 1 August 2026 17:1801.08.2026 17:18
So, I have successfully connected the micro receiver to the OFS3 and all functions seem to be working.

Now to Macrocell 15 - connection to the rescue function:

I have switch option 1 selected, meaning the lower left three-way switch is now active.
(The basic setup is in Mikado setting switch option 3. I have changed this to switch option 1)

And now I need HELP! ;-)

My three-way switch is intentionally installed in a reversed position: If I want to activate rescue, I only need to briefly tap the switch downwards from the center position with my middle finger to start the rescue sequence (spring-loaded, so just tap, the switch returns to the center position 0).

What exactly do I need to configure in the setup of macro cell 15?

It currently shows CH5: 3D ATT. (I don't want ATT mode.) In OFS, I've set CH5 for rescue. In macro cell 15: Position A appears when I tap the switch downwards, so A should trigger the rescue. (-125) is then displayed. Center is 0 and position B is (125).
So the switch control works.

I'll need a little step-by-step guide for that, unfortunately :-)
How do I assign the OFS rescue as such?

Thank you so much for your help!

greeting

Andreas



Edited 1 time(s). Last edit at 08/01/2026 05:20PM by TRACON.
machine-translated from German · Show original
TRACON 2 August 2026 11:4502.08.2026 11:45
If I leave the Mikado preset on Switch Option 3 (3D/ATT), pressing the corresponding switch in the MC menu shows no reading. Only the switch position is displayed.

Therefore, there will probably be no active switching from 3D to ATT?
machine-translated from German · Show original
Aaronheli 2 August 2026 18:5902.08.2026 18:59
Hello Andreas,

Depending on what you have set in the OFS3 app, either Attitude OR rescue mode will be activated via macro cell 15.
The app also describes this as follows: Attitude Mode is replaced by Rescue Mode. :-)

In macro cell 15, you simply select your switch (in your case Sw Op 1) and set the output signal to 100 in the desired switch position (top/middle/bottom), where the rescue mode should be active.

You can easily test it with the helicopter switched on to see if it works. The swashplate will briefly give a positive pitch when the rescue mode is triggered.

Greetings Aaron
machine-translated from German · Show original
TRACON 3 August 2026 10:2103.08.2026 10:21
Thanks Aaron, it works as described. :-)

I initially didn't notice any response from Pitch. After reinstalling it, it worked.

greeting

Andreas
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless