← VPlane / VBasic VLink

Curves with height correction translated

VBar › VPlane / VBasic VLink · Started by Volker Wahlen on 14 March 2025 08:3514.03.2025 08:35
Volker Wahlen 14 March 2025 08:3514.03.2025 08:35
Hello, I've recently taken up flying fixed-wing aircraft.
So far, "everything" is set up.
I managed to get the yaw trim right, both directions are even correct.
Now I wanted to do the same with the elevator.
I can only get that in one direction; in the other direction, the correction is inverted.
When flying a right or left turn, upward corrections are always necessary.
Which parameter do I need to adjust for it to work correctly?

Greetings from sunny Thailand

Volker

machine-translated from German · Show original
Eddi E. aus G. 14 March 2025 09:2014.03.2025 09:20
Good morning,

If I understand correctly, the way it is is correct for now: the trim changes the center (trim the control surface into the profile, or for certain flight conditions, trim against the center of gravity/pressure point or against a warped model).
That means if I trim by 'pulling', virtually the entire servo travel is reversed.

One could now mix in the height/crosswise function in the setup, but this only works as a percentage, so it works in one direction against the other.

Alternatively, one can take the macrocell CH1 (height), make it a mixer, and use as inputs CH1 (what would normally be output to CH1) and MC30 (any unused cell).

Then, cell 30, type curve, input FC Roll, and swirl a V-curve.

You can either leave the mixing ratios in cell CH1 at 100/100 and flatten the curve accordingly (fly it, 6 values to touch), or you create the V-curve in cell 30 +100...0...+100, and adjust it with the mixing ratio in CH1 (only one value to touch).

Or... you can simply pull back gently on the stick when flying a turn ^^ the mixing would potentially always turn rolls in straight flight into barrel rolls or other crippled results.

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
Volker Wahlen 14 March 2025 09:5614.03.2025 09:56
:-) Yes, I'll do the latter first :-)
The first one sounds very exciting. Let's see where it ends up.

I'm completely lost with the first paragraph. I stopped reading at the high school diploma level :-)
It's the end of the world here anyway. So I can still tinker with something.

Greetings from sunny Thailand

Volker
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless