← VBar Control Touch / EVO

Rear servo travel limiter translated

VBar Control › VBar Control Touch / EVO · Started by Broesel on 11 July 2026 19:2011.07.2026 19:20
Broesel 11 July 2026 19:2011.07.2026 19:20
Good morning,

A question for clarification:

On this model, the tail servo is presumably set to 100/100 in both full deflections, right?
To limit it, I would have to move the stick to its full stop - and thus potentially start running mechanically.

How do you solve that?
Should I first remove the poles and climb down, then slowly raise them, or am I missing something?

Best regards
Broesel
machine-translated from German · Show original
PMDirk 11 July 2026 20:2311.07.2026 20:23
Hello,

The starting value in the setup is 40 for both sides. If you adhere to the specified length for the tail servo arm, you can then adjust the values upwards so that nothing mechanically slips and ideally end up at around 100 per side.

Regards, Dirk



Edited once. Last edited on 11/07/2026 at 20:26 by PMDirk.
machine-translated from German · Show original
Broesel 12 July 2026 08:0812.07.2026 08:08
Good morning,

Okay, great!
So it's set so low that nothing triggers at first.

Great, thanks for the explanation!

Best regards
Broesel
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless