← XL Power Support

Vibration spectrum Stratos 200 translated

OEM models › XL Power Support · Started by thomas1130 on 18 August 2026 15:5918.08.2026 15:59
thomas1130 18 August 2026 15:5918.08.2026 15:59
Since I am "struggling" with increased vibrations on my 2-blade Stratos - in stark contrast to the 3-blade - I would naturally like to address the cause specifically.

Attached is a vibration spectrum from bank 1 - approximately 3780 rpm.

The main rotor seems "unobtrusive" to me.

But where do the vibrations at approximately 484 Hz come from?

And does the EVO really have information about the tail rotor speed?
- or is it somehow "interpolated"?

I suspect the rotational speed of the rear wheel is somehow at 484Hz - and not at 295Hz as displayed?

Thanks!

Best regards,
Thomas



Edited 1 time(s). Last edit at 08/18/2026 03:59PM by thomas1130.

machine-translated from German · Show original
JMalberg 18 August 2026 22:1718.08.2026 22:17
Hi Thomas,

Is it possible to find the KV and voltage at the rear motor to at least roughly explain the 29,000 rpm 484 Hz?

What happens without tail fins?

Regards, Jürgen
(Here are the missing commas for free use in my posts: ,,,,,,,,, )
machine-translated from German · Show original
Eddi E. aus G. 19 August 2026 09:1419.08.2026 09:14
Good morning,

So, first of all, no, the VBar doesn't know the tail rotor's RPM. It works like a tail servo; if necessary, it will control the servo or apply throttle to the limit. If that's not enough or too much, it will cause an aerodynamic stall, and the tail will spin out. The reverse is also true (if the tail motor is almost stationary but there's no counter-torque).

Incidentally, that would also be the limit of the TTE; it can only generate counter-torque by braking the motor until the motor stops... so it suddenly seems almost logical that the controller shuts down, braking the rotor until the model is barely controllable.
Torque can of course also be generated by gas, but only up to full throttle.
Physics will eventually bite everyone...

The helper elements (vertical lines, labels) are not an interpolation, but rather an interpretation, based on the assumption that the motor normally rotates at the highest speed (geared motor), the main rotor at the lowest (or we know the rotational speed with the governor or RPM signal), and the tail rotor at approximately a factor of 4.5-5 of the main rotor.

With direct drive using a rear motor, where the rear motor rotates somewhere between its lowest and highest speeds (fully unloaded or loaded), and where there are no two drive speeds, the current interpretation reaches its limits.

But something is 'raging' here at the top end of the scale, and the assumed tail rotation speed of 17,770 could be correct, but doesn't have to be; it's probably simply the 'catch factor' 17,770 / 3,720 = 4,778... there's no real action in the spectrum there either.

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless