← Logo 700 and 800

New Logo 700 available as a kit in the shop!! translated

Mikado Model Helicopters › Logo 700 and 800 · Started by Rolf Rakette on 4 August 2026 19:5004.08.2026 19:50
Rolf Rakette 4 August 2026 19:5004.08.2026 19:50
The new 700 series is now on sale.

I've had a look through the building instructions. It seems quite a few things are different.

Apparently, the rear-wheel drive is different.

Question: What are the O-rings on the couplings at the end of the rear drive tube for?

So I've correctly identified that there's an aluminum gear working inside the tail rotor?

The rotor head also appears to be constructed differently.

Then the static cable is also changed...

Best regards
Rolf
machine-translated from German · Show original
Eddi E. aus G. 5 August 2026 09:1405.08.2026 09:14
Hi Rolf,

Well spotted, Watson :-)

The fact is, and always has been, that the rigid drive is driven axially outwards in pirouettes.
And since this is becoming increasingly extreme, with drastic accelerations and decelerations under the heaviest loads, damping is appropriate.
A thrust bearing would also be an idea, but since it is not always under load (it makes no sense to put the rigid drive under tension...), it would quickly disintegrate into its individual parts when unloaded.

The bevel gear units are now a material mix, that's right: aluminum vs. reinforced plastic.
This makes the rear gearbox many times more robust, provided the backlash is correctly adjusted, which is also due to the ever-increasing loads on the rear axle.
Please invest a lot of care in selecting the shims, try them out, and only grease them at the very end, otherwise you'll hardly see/feel them anymore...

Roto head, yup, we've been working on this too, and again to either give 'wings' to the highest loads at high speeds, or alternatively to enable adapted damping for medium and low speeds.

Static cable is an extended precautionary measure; it is advisable to include all shafts and intermediate shafts (bearing blocks).
If you're already working on the whole system, you might as well tackle that too :-)

What you can't really see from the outside, and only become apparent from the inside in direct comparison, are the changes to the chassis, which, together with the rear tube, the adapter sleeves, etc., now enable the necessary stiffness and durability without bracing.

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless