Hi,
After having used my beloved Logo 10 (500mm leaves/490XL) for 3D exercises, I am now looking for a new HRW.
Since the 193mm version is no longer manufactured, I installed the short shaft from the 400 series. It looks like a Boomstrike to me, though.
I can mount the 199mm shaft of the 550SE 6mm lower, but unfortunately the lower bearing then sits exactly on the bore of the shaft.
What do the experts think?
Thank you in advance.
Regards, Ralph
After having used my beloved Logo 10 (500mm leaves/490XL) for 3D exercises, I am now looking for a new HRW.
Since the 193mm version is no longer manufactured, I installed the short shaft from the 400 series. It looks like a Boomstrike to me, though.
I can mount the 199mm shaft of the 550SE 6mm lower, but unfortunately the lower bearing then sits exactly on the bore of the shaft.
What do the experts think?
Thank you in advance.
Regards, Ralph
Hi,
nachdem ich meinen geliebten Logo 10 (500mm Blätter/490XL) bei 3D-Übungen gepflanzt hatte, suche ich nun eine neue HRW.
Da die 193mm nicht mehr hergestellt wird, hab ich die kurze Welle vom 400er montiert. Sieht mir aber nach Boomstrike aus.
Die 199mm Welle des 550SE kann ich zwar 6mm tiefer montieren, leider sitzt dann das untere Lager genau auf der Bohrung der Welle.
Was meinen die Profis?
Vorab Vielen Dank.
Gruß Ralph
nachdem ich meinen geliebten Logo 10 (500mm Blätter/490XL) bei 3D-Übungen gepflanzt hatte, suche ich nun eine neue HRW.
Da die 193mm nicht mehr hergestellt wird, hab ich die kurze Welle vom 400er montiert. Sieht mir aber nach Boomstrike aus.
Die 199mm Welle des 550SE kann ich zwar 6mm tiefer montieren, leider sitzt dann das untere Lager genau auf der Bohrung der Welle.
Was meinen die Profis?
Vorab Vielen Dank.
Gruß Ralph
machine-translated from German · Show original