← Logo 400 ... 690

Swashplate Logo 10 translated

Mikado Model Helicopters › Logo 400 ... 690 · Started by HelipilotMike on 7 June 2026 19:3607.06.2026 19:36
HelipilotMike 7 June 2026 19:3607.06.2026 19:36
Hello,
I need a new swashplate for my Logo 10! Are replacements still available? Or what would be an alternative? The black plastic ring on my swashplate has come loose. I noticed it when I was looking at it. Lucky me. I've been flying it since 2007. I'm grateful for any advice.
Greetings Mike
machine-translated from German · Show original
Christoph68 7 June 2026 22:5307.06.2026 22:53
Hi Mike,

I think the original throttle stem for the L10/L400 is already sold out, but maybe Mikado still has one. Or you could find one at an online retailer. Alternatively, the throttle stem from the larger Logo models should also fit (L550/600/690, which also have a 10 mm rear axle). It's a bit more robust and has a slightly different geometry, so you might have to adjust the throttle stem setup a bit. Or you could glue the inner ring into the metal part of the throttle stem. That happened with my L400SE years ago. It's held ever since I glued it in place. The newer throttle stems had a crimped edge, so this problem didn't occur with those.

Warm regards

Christoph
machine-translated from German · Show original
Eddi E. aus G. 8 June 2026 08:5608.06.2026 08:56
Good morning,

Uh... the world has turned twice as fast since then :-) from plastic to the 'small' aluminum swashplate to the current one.

'In principle' – correct – with small adjustments (checking paddle deflections, 8° and min./max. pitch with VBar, linkage lengths and free path on the shaft) any swashplate for 10 mm shafts will work, in this case this one .

But cleaning, roughening up a bit, and carefully gluing the joint in place with epoxy (making sure not to get the ball or bearings dirty ^^), as Christoph correctly writes, will probably last forever.

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
HelipilotMike 8 June 2026 15:4808.06.2026 15:48
Thanks :-)
machine-translated from German · Show original
HelipilotMike 8 June 2026 15:4908.06.2026 15:49
Okay, I'll give it a try. Thanks to both of you!
machine-translated from German · Show original
HelipilotMike 13 June 2026 13:3813.06.2026 13:38
So my logo is flying again! I glued the inner ring in with epoxy.
Greetings Mike
machine-translated from German · Show original
Eddi E. aus G. 15 June 2026 08:5215.06.2026 08:52
:-)

Born to fly ...
forced to work.
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless