← Logo 200

Logo200 Rescue translated

Mikado Model Helicopters › Logo 200 · Started by Nogowski on 19 June 2026 12:4419.06.2026 12:44
Nogowski 19 June 2026 12:4419.06.2026 12:44
Dear Mikado Team,
While testing the rescue function of my Logo 200 on the workbench, I noticed that when activating the rescue function, the Neo controls negative pitch even though I'm holding the pitch stick in the positive position. When I hold negative pitch, the Neo controls positive pitch.
I tested this in flight and the helicopter climbs downwards when I activate the rescue function while hovering, even though I maintain positive pitch.
Is there a way to fix this malfunction so that the rescue function works properly?
Vstabi Logo 200 Neo Micro SN 20053839 Firmware 6.4.16

Thank you in advance for your efforts.

With a request for further consultation, I remain, with kind regards, Klaus
machine-translated from German · Show original
Eddi E. aus G. 19 June 2026 13:0619.06.2026 13:06
Hello Klaus,

What is the value set for pitch after rescue in the rescue setup (please cycle through the banks and check all values)?

And what does the rescue status display show when the model is simply sitting on the table?

In VBar Control Classic, go to Model Settings / Rescue.

If a rescue is initiated, is the rescue triggered (with announcement or log entry), or – if set so – is the hover mode activated (switching function reversed?), and the rescue is in the other switch position?

—Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
Nogowski 19 June 2026 15:0319.06.2026 15:03
Dear Mr. Eddi,
Thank you very much for your quick response. The "Pitch after rescue" value was set to 0 on all three banks for me.
I set the first bank to 85 and lo and behold, it maintained a positive pitch and Neo is also giving a positive pitch. Then I switched to banks two and three, which were still at zero, and Neo is again giving a negative pitch.
What value do you recommend for a pitch after a rescue?
Thank you very much for your professional and, above all, successful support.
Kind regards, Klaus.
machine-translated from German · Show original
Bernd S. 20 June 2026 09:1820.06.2026 09:18
Good morning,

I would adjust the pitch values so that the helicopter climbs SLOWLY.

I don't have the rescue function in the L200 yet - but I do have it in the L600SE, and the default value made the helicopter climb too high when activated - that would be suboptimal in a hall 8-) .

-> fly each bank

And it's always good to test that beforehand.
machine-translated from German · Show original
Eddi E. aus G. 22 June 2026 09:1222.06.2026 09:12
Hello Mr. Klaus :-)

Someone's been messing around with it ;-)

The value is set to 65 by default (even for the 200 model), meaning that during the rescue, approximately 65% of the total pitch (positive when the skids are down, negative when inverted, 0 when controlled through knife-edge flight, and then increasing when normal flight attitude is reached) is applied simultaneously with the cyclic deflection in order to rotate simultaneously and, if the rotor can engage, to generate controlled lift.

0 means that 0° pitch is used, only rotation occurs.

This means that if the aircraft is in a positive position (on the ground or hovering), a pitch of 0° will be applied, and the model will descend. On the ground, it appears as if negative pitch is being applied (actually: pitch is being removed).

No malfunction...

It _could_ even be set to negative values, so that, for example, the rescue system could be used during the descent phase of an inverted autorotation to rotate the model without losing any significant amount of stored kinetic energy in the rotor. However, the rescue system would then continue to descend in normal flight attitude until intervention occurs, so it should be used carefully and/or early.

Editor's note: Autorotation and LOGO 200 don't really go together, #Direct Drive.

Then, as Mr. Bernd :-) writes: adjust it so that the helicopter takes off safely, but doesn't necessarily shoot into the sky like a cork popping out of a bottle.
However, please bear in mind that hovering is only one flight condition... when flying 'downwards', more pitch is needed to stop the momentum, so if you are flying more dynamically and at a lower altitude, it is not a bad thing if the rescue system has some power.

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
Bernd S. 26 June 2026 11:0626.06.2026 11:06
Mr. Bernd? -> Mr. S. from L. :-)

That's right, you shouldn't set the rescue pitch too softly because otherwise the helicopter won't be able to "make the turn before impact" - especially if it's a steep downhill slope (as Eddi writes) - I hadn't even considered that because I tend to drive slowly and cautiously.

Champagne cork pitch is certainly a good source of clickbait YouTube videos in the hall - it's simply not a single, universally correct setting for climbing in the rescue system.

Greetings from Mr. S. from L.
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless