I have just bought the new glogo kit and i’m not impressed with the slots in the frame for the engine mount bolts. The slots look to be already incorporated at the factory, but the problem is the size of them, they look like they have just been filed out freehand, so the holes are quite oversize. With the bolts loose, the engine mount is moving around the oversize hole, or slots if you prefer all over the place. This will not make engine alignment great.
Not what you would expect from a new machine of this pedigree that’s for sure.
My question is will mikado be replacing these frames for people with early production kits. I have not started to build it yet, and if i’m honest, i’m loathed to with it like this.
The other issue is with the engine mount pushed all the way down the slots as the note suggests, the lower plate mounting holes are lower than the u/c mounting holes. Putting a little twist in the plate is not great either.
I noticed on this forum someone else has asked the question about the frames being replaced, sadly it has not been answered, so i’m sorry for asking the same question again...
Dave
Not what you would expect from a new machine of this pedigree that’s for sure.
My question is will mikado be replacing these frames for people with early production kits. I have not started to build it yet, and if i’m honest, i’m loathed to with it like this.
The other issue is with the engine mount pushed all the way down the slots as the note suggests, the lower plate mounting holes are lower than the u/c mounting holes. Putting a little twist in the plate is not great either.
I noticed on this forum someone else has asked the question about the frames being replaced, sadly it has not been answered, so i’m sorry for asking the same question again...
Dave