The Expert Aux App has a nice table layout howerver there is some confusion in the table.
Is the "Makrocells" for the Pro Aux app or the Expert Aux app, the table indicates Pro Aux however the table is shown under the Expert Aux app?
Please explain how a cell is mapped to a channel and how this correlates to which pin out on a vbar-mini device.
Now for the real question, I have an airplane that I would like to try this out on and I have two aileron servos, two elevator servos, a rudder servo and a ESC, wishing to use the Vbar-Mini and no Y connectors I see the table Makrocells show that I can have two aileron and two elevator servos, what is missing is the physical part which shows the mapping to the mini -vbar. I would need a way to map the RD, K3, K2, K1, RX C, RX B and RX A to the physical outputs of the vbar and am unclear based on the Makrocells table.
Please define each output with its pinouts, I understand RXC, RXB and RXA are only outputs and have no +/- pins for servos, which will require me to make a custom harnesss which is easy. I just dont want to spend hours trying to figure out the mapping and which pins do which function.
Thanks
Chris
Is the "Makrocells" for the Pro Aux app or the Expert Aux app, the table indicates Pro Aux however the table is shown under the Expert Aux app?
Please explain how a cell is mapped to a channel and how this correlates to which pin out on a vbar-mini device.
Now for the real question, I have an airplane that I would like to try this out on and I have two aileron servos, two elevator servos, a rudder servo and a ESC, wishing to use the Vbar-Mini and no Y connectors I see the table Makrocells show that I can have two aileron and two elevator servos, what is missing is the physical part which shows the mapping to the mini -vbar. I would need a way to map the RD, K3, K2, K1, RX C, RX B and RX A to the physical outputs of the vbar and am unclear based on the Makrocells table.
Please define each output with its pinouts, I understand RXC, RXB and RXA are only outputs and have no +/- pins for servos, which will require me to make a custom harnesss which is easy. I just dont want to spend hours trying to figure out the mapping and which pins do which function.
Thanks
Chris