CJS4
10 November 2015 12:0610.11.2015 12:06
I have just set up my first VPlane.
Banks 1 & 2 have identical settings except that bank 1 has 0 gain. As I understand it, this means that there is no stabilisation in bank 1. When I test it on the bench by moving the model, in bank 1 the control surfaces move just as they do in the other two banks. Is this correct?
Thanks
ulrich
10 November 2015 22:0510.11.2015 22:05
No that not correct.
Did you do a setup with the Setup wizzard? There the Bank 0 is defined with no gains, so the surfaces do not move at all if the plane is moved.
If you have a diffferent setup, there may be some I Gain still in the loop if you dial the Gain to 0. Check out the expert gain settings. Integral shall be 0 as well to completely disable the gyro.
so long ... Uli
http://www.vstabi.de
CJS4
11 November 2015 10:4611.11.2015 10:46
Thanks Uli
You were quite right, there was some Integral gain.
I have set it to 0 and all is well.
mpolzin
12 December 2015 14:5212.12.2015 14:52
I am brand new to Vplane. I did use the setup wizzard and the default for bank 1 on main gain is "0" but for all of the banks the default for the locking is "0" Balance is "70" and Integral is "32". Do I need to set the Balance and Integral to "0" to fully turn off the gyro? Or does just the Integral need to be set to "0"?
RV
12 December 2015 18:3412.12.2015 18:34
I think zeroing the gain will be enough. Just zero it - and move the sensor while watching the servos ;-)
regards (EN) / Gruss (DE)
Rainer Vetter
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.
Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.