I am using Vbar Neo with Vplane and I have a general question. If one accidentally enables Auto Trim for a few seconds on the bench and not in flight. Will I have to next time I fly , take off in manual flight mode ( Typically set to bank 1 ) and then do the autotrim all over again ? Or is there a minumum poeriod of time that auto trim can be enabled ( in this case accidentally ) before it starts making changes to what it sees as trim flight. So I would not want to take off next time not knowing if my autotrim setting was messed up with me accidentally enabling it for a few seconds on the bench. Thanks
Vplane Auto Trim Question
VBar › VPlane / VBasic VLink ·
Started by gizmodude on 8 March 2025 20:0008.03.2025 20:00
gizmodude
8 March 2025 20:0008.03.2025 20:00
Eddi E. aus G.
10 March 2025 15:1110.03.2025 15:11
Hi,
in fact, you can even take off with auto trim enabled, fly a pattern, disable when ist’s done.
Nothing to worry, even if it was switched on accidentally, you always have control, and it’s adjusting quickly anyway.
Kind regards
Eddi
Born to fly ...
forced to work.
in fact, you can even take off with auto trim enabled, fly a pattern, disable when ist’s done.
Nothing to worry, even if it was switched on accidentally, you always have control, and it’s adjusting quickly anyway.
Kind regards
Eddi
Born to fly ...
forced to work.