Ok, so, I've gone down a pretty complicated path of getting a turbine jet setup on VPlane. Am experiencing some really weird issues with the setup though.
Jet config: Dual aileron servos, Dual flap servos, dual elevator servos, rudder servo, steering servo, retracts and brakes.
Issues:
* Macrocells do not always show their names.
This is a really odd one, and mainly just a frustration as I was trying to go through and change settings. It's a little difficult to change a cell when you have to remember the channel number rather than just see it by name. It does seem to only correct itself if you power off the model and power up again.
* Model throws in setup.
I'll be honest, this one is on me for not RTFM. https://www.vstabi.info/en/node/1786 Either the How to setup section needs to be moved up in the current very out of date VPlane manual, or a new manual should be put together. It makes sense once you get to the bottom of the section and see it. But it's not how one would normally think of setting up a plane.
* Automatic parameter change from a dial.
I might be crazy, but I could have sworn there was a way on the first gen VControl that you could pull up an adjustment on screen and then just have to turn a dial and it would automatically allow you to control that feature while flying. I have yet to figure out how to get this feature again. I know you have the assignable dials in Modify Config, but that menu doesn't allow you to assign dials to things like Integral Gain/Range, etc.
Any feedback, thoughts, comments????
1 mal bearbeitet. Zuletzt am 27.05.2026 08:25 von nem3_2.
Jet config: Dual aileron servos, Dual flap servos, dual elevator servos, rudder servo, steering servo, retracts and brakes.
Issues:
* Macrocells do not always show their names.
This is a really odd one, and mainly just a frustration as I was trying to go through and change settings. It's a little difficult to change a cell when you have to remember the channel number rather than just see it by name. It does seem to only correct itself if you power off the model and power up again.
* Model throws in setup.
I'll be honest, this one is on me for not RTFM. https://www.vstabi.info/en/node/1786 Either the How to setup section needs to be moved up in the current very out of date VPlane manual, or a new manual should be put together. It makes sense once you get to the bottom of the section and see it. But it's not how one would normally think of setting up a plane.
* Automatic parameter change from a dial.
I might be crazy, but I could have sworn there was a way on the first gen VControl that you could pull up an adjustment on screen and then just have to turn a dial and it would automatically allow you to control that feature while flying. I have yet to figure out how to get this feature again. I know you have the assignable dials in Modify Config, but that menu doesn't allow you to assign dials to things like Integral Gain/Range, etc.
Any feedback, thoughts, comments????
1 mal bearbeitet. Zuletzt am 27.05.2026 08:25 von nem3_2.