← VBar NEO/EVO VLink

Mini vbar software

VBar › VBar NEO/EVO VLink · Started by yowser on 14 November 2019 13:1714.11.2019 13:17
yowser 14 November 2019 13:1714.11.2019 13:17
Will the 5.2 mini vbar run on the 6.3 software on my computer? I believe that is my problem, won't connect but recognizes that a usb is plugged in. Also should I update the mini to 6.3 or just load the 5.2 on the computer?
RV 14 November 2019 13:5214.11.2019 13:52
Updating a OLD VBAR (Mini and Full) requires a V5.3 PC Software always.
Updating to a V6 for VC will disable USB afterwards.
For Re-Enabling use Recovery Procedure if needed.

Setup can be done with the V5.3 ONLV for the 5.3 Control (non VBC Radios).
The V6.0 for VBC Firmware MUST be set up and used with a VBC.

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
VStabi VStabi Pioneer of Flybarless