← VBar Control Touch / EVO

My default switches don’t talk anymore!!

VBar Control › VBar Control Touch / EVO · Started by George on 4 December 2025 15:3204.12.2025 15:32
George 4 December 2025 15:3204.12.2025 15:32
When I used to flip the motor to on, it would say motor on, motor idle, and motor off. It would also say bank 1, bank 2 and bank 3. (All by default I think) now it says nothing. I did set up a switch to say “normal mode” and stability mode” that switch still talks like it should. Motor hold and banks switch say nothing.
Everything used to work I’ve changed nothing that I know of. Any helpful would be greatly appreciated.
Volume is at 100%
I’m running V8 firmware.
I have Susan active, talking telemetry active, talking switches and talking switches pro all active.

HELP!


Thank you.
Eddi E. aus G. 4 December 2025 16:0404.12.2025 16:04
Hi,

please disable the regular talking switches as you have Pro enabled.
Only one at a time.
Then, either set up the default switches manually, too (it's Pro after all, so everything is user-defined), _or_ start with selecting one of the Presets at the bottom of the list.

Best,

Eddi

Born to fly ...
forced to work.
George 5 December 2025 01:0605.12.2025 01:06
So FYI for anyone that may experience this I figured it out. I pretty much had to uninstall anything talking, audio related and then I reinstalled it and I made sure the default talking was on and then I set it up on switches, etc. how I liked.
VStabi VStabi Pioneer of Flybarless