← VBar Control Touch / EVO

Vbar backup not disconnecting after 10 seconds

VBar Control › VBar Control Touch / EVO · Started by Jsibal on 9 November 2025 06:5709.11.2025 06:57
Jsibal 9 November 2025 06:5709.11.2025 06:57
Hi

I installed a vbar backup on my goblin 700. After landing and going to motor off then disconnecting my battery packs the vbar backup doesn’t go to sleep. I don’t touch the radio.

I am using a scorpion tribunus II 200 amp with an external bec.

The vbar backup is connected through the mikado gps sensor telemetry port (daisy chain)

Please do let me know the issue

Thanks
Jsibal 9 November 2025 07:0109.11.2025 07:01
Hello

I installed a new vbar backup on a goblin 700. After landing and going to motor off and disconnecting the man battery pack and not touching the radio for more than 10 seconds the vbar backup doesn’t shut down and it only does after the capacitors drain.

I am using a scorpion tribunus II 200 amp with an external bec.

The vbar backup is connected through the mikado gps sensor telemetry port (daisy chain).

The vbar backup is detected and I can control all parameters however it doesn’t auto switch off.

Thanks
Jsibal 9 November 2025 07:2709.11.2025 07:27
Also another issue I am facing is that active idle doesn’t seem to be working anymore.

When I connect the power to the model the radio doesn’t turn on. I can confirm that the radio is not fully off as the red light is visible behind the radio.

This is the vbar control touch

Thanks
Jsibal 9 November 2025 08:4609.11.2025 08:46
Ok I have solved the vbar backup standby issue. Cannot daisy chain it through the GPS sensor. I connected it directly to vbar and it works

However active idle is not working. I can confirm the radio is not off and the battery charge level is well above 10%. This issue has been happening since full charge.

I have a vbar touch with the Multi region module set to dynamic.


Thanks
VStabi VStabi Pioneer of Flybarless