GreenMeanie
24 September 2025 23:3624.09.2025 23:36
Before I take out Switch 6 is there a way to use the MOTOR setting on it and when pulling towards you have the engine run and if pulled towards you again have it use AR/idle?
EX - Switch at bottom would be OFF then middle would be IDLE/AR then if pulled forward again middle would be Motor Run then if pulled forward again middle would go back to ar/idle.
Edited 1 time(s). Last edit at 09/24/2025 11:37PM by GreenMeanie.
Eddi E. aus G.
25 September 2025 09:0025.09.2025 09:00
Hi,
no, that's not possible. All switches work A-0-B (like, Off, Idle, Run, or Bank 1, 2, 3), but they don't toggle (like Idle, Run, Idle).
The spring loaded switches are meant for temporary functions like triggering Rescue (hit a button and forget, it will re-arm when it springs back) or run Buddy mode (release switch to take over again), or to actuate Throttle hold (close carb when the switch is pulled or pushed, open back to idle again when it's released).
Replacing switches 1 and 6 is not a big deal, though, since for once, you can loosen the finishing nut with a simple 9 mm spanner, and since it's plugged in separately on the mainboard anyway. Any On-Off-On type of switch which fits the hole will do.
I'd go for a new switch any time so I wouldn't have to swap the more recessed switches, re-route wires, and un-/plug what doesn't need to be, as not to risk damaging anything in the process.
—Eddi
Born to fly ...
forced to work.
GreenMeanie
25 September 2025 21:3825.09.2025 21:38