← VBar Control Touch / EVO

Servo Center Trim

VBar Control › VBar Control Touch / EVO · Started by busterboy on 16 July 2018 13:4816.07.2018 13:48
busterboy 16 July 2018 13:4816.07.2018 13:48
Forgive me for asking the obvious but have we lost the servo center app like in the original VControl or have I missed it somewhere.

I can see Trim Values Ch1 - Ch4 in the setup and can adjust there but lost servo centre trim.

Below I can see Cyclic calibration (Zero at trim) for the 8 degrees cyclic pitch which is next on the setup.

EDIT: Dammit I found it, Do a long click on (TRIM) and its there.. :-)



Edited 5 time(s). Last edit at 07/17/2018 12:45AM by busterboy.
muzz 16 July 2018 13:5516.07.2018 13:55
Glad you asked Busterboy I would like to know also
As I have a heli to setup for a friend on the weekend



Edited 1 time(s). Last edit at 07/16/2018 01:56PM by muzz.
busterboy 16 July 2018 13:5516.07.2018 13:55
muzz Wrote:
-------------------------------------------------------
> Glad you asked Bustboy I would like to know also
> As I have a heli to setup for a friend on the week
> nd

Found it, read my post above. :-)
muzz 16 July 2018 13:5716.07.2018 13:57
What are you long pressing on?
busterboy 16 July 2018 14:0216.07.2018 14:02
muzz Wrote:
-------------------------------------------------------
> What are you long pressing on?

The TRIM button in main rotor setup mode. Hold down until it appears. :-)

Alternatively press the ? button to the right and it tells you in there. :-)



Edited 1 time(s). Last edit at 07/16/2018 02:04PM by busterboy.
muzz 16 July 2018 14:0316.07.2018 14:03
Thank you
Fingolf 16 July 2018 14:0316.07.2018 14:03
You can long click on each element with a small blue corner for expert settings.

Stephan
busterboy 16 July 2018 14:0816.07.2018 14:08
Fingolf Wrote:
-------------------------------------------------------
> You can long click on each element with a small
> blue corner for expert settings.
>
> Stephan

We are learning Stephan slow but sure.. :-)
VStabi VStabi Pioneer of Flybarless