← VBar Control Touch / EVO

Teacher/student with satellite receiver doesn't work translated

VBar Control › VBar Control Touch / EVO · Started by daniel712 on 9 September 2026 23:0409.09.2026 23:04
daniel712 9 September 2026 23:0409.09.2026 23:04
Hello Mikado Team,

I fly my Ombophy M2 with the vBar Touch. For this, I installed the Mikro SBUS receiver.
Unfortunately, this doesn't work with L/S.

Is there a trick to it, or is it not possible due to system limitations?

Thank you very much and best regards
Daniel
machine-translated from German · Show original
Eddi E. aus G. 10 September 2026 10:0010.09.2026 10:00
Good morning,

I think it's because everything runs through free mixers (macro cells), directly from stick/switch (of the bound transmitter) -> (mixer) -> S.BUS output.

Functions other than the normal controls (sticks) are never taken over by the student, only the calculated stick inputs (original functions, FC pitch-roll-tail input), which, however, run into nothing in the configuration.

The trick would be to choose the calculated functions FC*** in the relevant macro cells instead of the raw stick inputs, pitch and roll***.
But then the problem arises that one could change the input signal via agility (such as dual rate) and expo, for example (or would have to adapt it to what the external flight control wants/needs).

However, this was not desired at the present (or then) time, or (strongly suspected) there is even an error in the preset – after all, the preliminary page in the model setup states that agility 65 Expo 0 should remain set, which in my opinion they are not, since the stick is set to full travel as an input, where agility and expo have no effect on the flight parameters (shouldn't/shouldn't?).

If I change this for MC11/E1CH1 Roll to FC Roll, ..CH2 Nick to FC Nick, ..CH4 Tail to FC Tail, I can switch the three functions with L/S.
Interestingly (see above), max. Nick then changes from +/- 100 to +/- 78 (65% maneuverability of the max. range of 120% including everything, the values mentioned on the introductory page, which also do not correspond to 65 if that is really desired).

While roll-pitch-tail a solvable equation would be, I wouldn't know where to get the native pitch function from, which doesn't exist with a pure receiver (without a hand-built swashplate mixer, which then also doesn't have the original function). There, the throttle stick has a single, unambiguous function: throttle.

Thinking further: 'One could' of course use FC ESC as the input for the pitch curves, thus essentially controlling the throttle function (which can be passed on to the receiver), but this means that the motor switch then has idle throttle as a fixed pitch position and motor off as full negative pitch.
That would be at least... unusual :-) and in my opinion not really practical or dangerous in practice.

Perhaps Rainer will think of something else that I'm overlooking.

Grüßle

Eddi

Born to fly ...
forced to work.
machine-translated from German · Show original
daniel712 10 September 2026 10:3910.09.2026 10:39
Oh, I can't and don't want to delve that deeply into it... I'd rather take a different helicopter with EVO... :-)

Thank you so much for the detailed explanation!!!



Edited once. Last edited on 10/09/2026 at 10:40 by daniel712.
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless