Good morning,
A question for clarification:
On this model, the tail servo is presumably set to 100/100 in both full deflections, right?
To limit it, I would have to move the stick to its full stop - and thus potentially start running mechanically.
How do you solve that?
Should I first remove the poles and climb down, then slowly raise them, or am I missing something?
Best regards
Broesel
A question for clarification:
On this model, the tail servo is presumably set to 100/100 in both full deflections, right?
To limit it, I would have to move the stick to its full stop - and thus potentially start running mechanically.
How do you solve that?
Should I first remove the poles and climb down, then slowly raise them, or am I missing something?
Best regards
Broesel
Moin,
Eine Verständnisfrage:
Bei beim Modell steht das Heckservo ja vermutlich auf 100/100 in beiden Vollausschlägen oder?
Um es zu begrenzen muss ich ja dann den Knüppel auf vollanschlag bringen - und laufe damit eventuell ja schon mechanisch an.
Wie löst ihr das?
Erstmal Gestänge ab und runtersteigen u d dann langsam erhöhen oder hab ich einen Denkfehler?
Viele Grüße
Broesel
Eine Verständnisfrage:
Bei beim Modell steht das Heckservo ja vermutlich auf 100/100 in beiden Vollausschlägen oder?
Um es zu begrenzen muss ich ja dann den Knüppel auf vollanschlag bringen - und laufe damit eventuell ja schon mechanisch an.
Wie löst ihr das?
Erstmal Gestänge ab und runtersteigen u d dann langsam erhöhen oder hab ich einen Denkfehler?
Viele Grüße
Broesel
machine-translated from German · Show original