Hello!
Updated my VControl Touch Evo Plus with the MR module. Once completed I checked all my travels and switches and decided to review my TX/RX status. I noticed that the left hand bar of my TX never goes to 100% like the right hand bar. I have it set to Dynamic in the photos attached. The larger horizontal bar will show perfect or near perfect most of the time but the left hand bar wont really go above 75%. I took the transmitter apart again to ensure the antennas were connected correctly. I did notice that the left hand bar is reflecting the status of the antenna the connects to the green board that sits just below the actual antenna shell. Is this normal operation? Or do I have an issue? Havent been able to attempt a flight yet but slightly hesitant to fly without a little more feedback from the experts.
Thanks for your help!
Updated my VControl Touch Evo Plus with the MR module. Once completed I checked all my travels and switches and decided to review my TX/RX status. I noticed that the left hand bar of my TX never goes to 100% like the right hand bar. I have it set to Dynamic in the photos attached. The larger horizontal bar will show perfect or near perfect most of the time but the left hand bar wont really go above 75%. I took the transmitter apart again to ensure the antennas were connected correctly. I did notice that the left hand bar is reflecting the status of the antenna the connects to the green board that sits just below the actual antenna shell. Is this normal operation? Or do I have an issue? Havent been able to attempt a flight yet but slightly hesitant to fly without a little more feedback from the experts.
Thanks for your help!