Hi guys,
My stock VBC Evo+ has two peculiarities:
1. When I turn it on, the battery indicator shows x%. After a few minutes, the indicator then shows between x+5 and x+10%. This is somewhat confusing.
2. The transmitter often doesn't wake up from standby mode when I try to bind an Evo VBar. Or it can't bind it at all (even though it's listed in the bind menu) when I explicitly try to do so. Rebooting the VBar then solves the problem.
These aren't major problems, I'm very satisfied overall, but maybe you could take a look at them.
Best regards,
Johannes
Edited once. Last edited on 02/11/2025 at 17:03 by jgmeiner.
My stock VBC Evo+ has two peculiarities:
1. When I turn it on, the battery indicator shows x%. After a few minutes, the indicator then shows between x+5 and x+10%. This is somewhat confusing.
2. The transmitter often doesn't wake up from standby mode when I try to bind an Evo VBar. Or it can't bind it at all (even though it's listed in the bind menu) when I explicitly try to do so. Rebooting the VBar then solves the problem.
These aren't major problems, I'm very satisfied overall, but maybe you could take a look at them.
Best regards,
Johannes
Edited once. Last edited on 02/11/2025 at 17:03 by jgmeiner.
Hi Leute,
meine Stock - VBC Evo+ hat zwei Eigenheiten:
1. Wenn ich sie einschalte, dann ist die Akku-Anzeige bei x%. Nach ein paar Minuten zeigt mir die Anzeige dann zwischen x+5 bis x+10 % an. Das ist etwas verwirrend.
2. Die Funke wacht oft nicht aus dem Standby-Modus auf, wenn ich ein Evo Vstabi binde. Oder kann dies auch nicht binden (obwohl im Binden-Menue angezeigt), wenn ich das explizit machen will. Ein Reboot vom Vstabi loest dann das Problem.
Das sind jetzt keine Grossen Probleme, bin sehr im Grossen und Ganzen sehr zufrieden, aber vielleicht koennt ihr euch das mal ansehen.
Lg,
Johannes
1 mal bearbeitet. Zuletzt am 02.11.2025 17:03 von jgmeiner.
meine Stock - VBC Evo+ hat zwei Eigenheiten:
1. Wenn ich sie einschalte, dann ist die Akku-Anzeige bei x%. Nach ein paar Minuten zeigt mir die Anzeige dann zwischen x+5 bis x+10 % an. Das ist etwas verwirrend.
2. Die Funke wacht oft nicht aus dem Standby-Modus auf, wenn ich ein Evo Vstabi binde. Oder kann dies auch nicht binden (obwohl im Binden-Menue angezeigt), wenn ich das explizit machen will. Ein Reboot vom Vstabi loest dann das Problem.
Das sind jetzt keine Grossen Probleme, bin sehr im Grossen und Ganzen sehr zufrieden, aber vielleicht koennt ihr euch das mal ansehen.
Lg,
Johannes
1 mal bearbeitet. Zuletzt am 02.11.2025 17:03 von jgmeiner.
machine-translated from German · Show original