Hello, I just finalizing setup (DX9 TX, DSMX satellites) with new Neo , which I recently bought, and wondering about same thing.
With Neo/6.1 software no Throttle channel signal from TX to ESC anymore! Even in "External governor" mode! Just synthetic "Motor" signal from Neo... Which actually make NOT possible:
* have different RPM within one bank
* using Throttle curves from TX
Also make difficult initial ESC programming (min/middle/max points, etc)
So, two question:
1) What's the reason you implement such (strange and unusual) behavior?
2) Any possibility to have that changed? With featured software/firmware updates?
Thanks in advise!
2 mal bearbeitet. Zuletzt am 20.07.2015 01:26 von 3Daemon.
With Neo/6.1 software no Throttle channel signal from TX to ESC anymore! Even in "External governor" mode! Just synthetic "Motor" signal from Neo... Which actually make NOT possible:
* have different RPM within one bank
* using Throttle curves from TX
Also make difficult initial ESC programming (min/middle/max points, etc)
So, two question:
1) What's the reason you implement such (strange and unusual) behavior?
2) Any possibility to have that changed? With featured software/firmware updates?
Thanks in advise!
2 mal bearbeitet. Zuletzt am 20.07.2015 01:26 von 3Daemon.