← Flight Trainer

Pin assignment on the Neo mini translated

Mikado Model Helicopters › Flight Trainer · Started by marcelall on 7 May 2025 20:4707.05.2025 20:47
marcelall 7 May 2025 20:4707.05.2025 20:47
Hello everyone
Since I only have the original Vbar Control basic, I had to do the update on the Neo Mini using the cable.
Even though I labeled the cables, I've still managed to make a mess. Could you post a list or a picture showing what goes where?

Thanks and regards
Marcel
machine-translated from German · Show original
Eddi E. aus G. 8 May 2025 08:5808.05.2025 08:58
Good morning,

Here is the table.

The swashplate servos are, by default, CH1 (rear), CH2 (left roll), CH3 (right roll).

The note about booting and no power refers to VBar NEO (standard), where the connection is at the back.
The NEO mini uses a servo connection for this purpose, as it can/has voltage on it, or a servo is attached to it during flight.

Greetings

Eddie

Born to fly ...
forced to work.

machine-translated from German · Show original
marcelall 14 May 2025 20:4414.05.2025 20:44
Super

Thanks for the list.

The little one is flying again.

Regards, Marcel
machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless