I bought the hard dampers for logo 700 head, but I want to know if I install it inside or outside the head!? There is 3 dampers each side, I need to change all of it?
Hard dampers
Mikado Model Helicopters › Logo 700 and 800 ·
Started by norser on 15 July 2017 19:3715.07.2017 19:37
norser
15 July 2017 19:3715.07.2017 19:37
HeliALEX
17 July 2017 10:0217.07.2017 10:02
Hello,
if you want to use the hard dampers (90 shore) please replace only two of them, the ones facing to the outside of the main rotor head yoke/ to the blade grips.
if you want to use the hard dampers (90 shore) please replace only two of them, the ones facing to the outside of the main rotor head yoke/ to the blade grips.
Marianovbar
14 February 2022 21:5514.02.2022 21:55
Hello, harder dampers require more cyclic gain or is indifferent?
Regards
Regards
Eddi E. aus G.
15 February 2022 08:4815.02.2022 08:48
Hi,
technically, the harder the dampeners the higher is the mechanical gain, figuratively speaking The more direct the head acts or reacts.
So it could even be necessary to dial down the overall gain, if you see or more likely hear oscillation building, in hard stops.
But since VBar has so much filtering and so many feed forwards and adaptive components implemented, it's imo a) not necessary to max out the gain and b) if not maxed out already, there's a very wide band of values which work well.
Just try.
Kind regards
Eddi
Born to fly ...
forced to work.
technically, the harder the dampeners the higher is the mechanical gain, figuratively speaking The more direct the head acts or reacts.
So it could even be necessary to dial down the overall gain, if you see or more likely hear oscillation building, in hard stops.
But since VBar has so much filtering and so many feed forwards and adaptive components implemented, it's imo a) not necessary to max out the gain and b) if not maxed out already, there's a very wide band of values which work well.
Just try.
Kind regards
Eddi
Born to fly ...
forced to work.