I'm flying an Vario "Aircrane" (Skycrane S-64) with Jet Cat SPH-5.
2 meter rotor at 850 rpm, TOW 17 kg.
I use VBar EVO VLink and the first version of VBC-touch.
It was a bit of a journey to find working parameters and mechanical setup for the tail control.
In short, the setup wizard led my kind of wrong here and some radical changes were needed.
So, I'm checking the interest in this topic first before I put out the full story and my current parameter set.
2 meter rotor at 850 rpm, TOW 17 kg.
I use VBar EVO VLink and the first version of VBC-touch.
It was a bit of a journey to find working parameters and mechanical setup for the tail control.
In short, the setup wizard led my kind of wrong here and some radical changes were needed.
So, I'm checking the interest in this topic first before I put out the full story and my current parameter set.