{"ok":true,"content":"Eddi E. aus G. Wrote:\r<br>\n-------------------------------------------------------\r<br>\n&gt; Hi,\r<br>\n&gt; \r<br>\n&gt; a voltage drop is usually not a thing of settings,\r<br>\n&gt; unless a servo would bind and draw excessively\r<br>\n&gt; high amps.\r<br>\n&gt; And even then, the blocking current is usually way\r<br>\n&gt; less than the peak current in changes of\r<br>\n&gt; direction, which happen all the time on the main\r<br>\n&gt; rotor or the tail rotor.\r<br>\n&gt; It's a thing between the consumers and the power\r<br>\n&gt; supply.\r<br>\n&gt; \r<br>\n&gt; What servos and what power supply are you using,\r<br>\n&gt; and how's everything wired?\r<br>\n&gt; \r<br>\n&gt; Kind regards\r<br>\n&gt; \r<br>\n&gt; Eddi\r<br>\n\r<br>\n\r<br>\nThanks for kindly helping much appreciated. I have set the max and min throttle servo throw in vbar so it shouldn't bind should it?\r<br>\n\r<br>\nMy set up is as follows\r<br>\n\r<br>\nVbar Neo Pro latest firmware\r<br>\nFutaba R7008SB reciever\r<br>\nFutaba 14sg transmitter\r<br>\nFutaba S3071 throttle servo\r<br>\nJR NXB89G tail\r<br>\nJR NX8935 cyclic\r<br>\nOs 105hzr\r<br>\nOptipower 2cell reciever lipo\r<br>\nOptipower ultraguard \r<br>\nHirobo Freya","note":""}