{"ok":true,"content":"Hi,\r<br>\n\r<br>\nwell, full throttle and low throttle mean the governor can not open the carb any more to maintain the head speed under high\/prolonged high load, or close it any more (main rotor and magnets overspeeding in the descent).\r<br>\n\r<br>\nIt's a matter of the overall setup, requested head speed, max. collective, engine tuning (for full load situations), for unloaded situations it can be considered OK, because you probably want the engine to remain at increased idle so it doesn't bog when you request power again, and quickly.\r<br>\n\r<br>\nSensor out of range is\u2014vibration wise\u2014the next level after Extreme\/Dangerous vibration.\r<br>\n\r<br>\nVibration is a killer, for gyroscopic sensors as well as for accelerometers. Things you can do: check that the main board is fixated properly inside the case (replace case if in doubt), mount the NEO as far away from the engine\/gearbox as possible (behind the mast has proven to be best practice over the years), make sure wires are not taut but fixated after half an inch to an inch, try a different mounting tape, double tape, or sandwich with a metal plate, all the things which you'd also have tried if you had experienced drift with legacy tail gyros after all.\r<br>\nCheck that the NEO is standing free, not squeezed in between wires or touching frames or anything but the tape.\r<br>\n\r<br>\nPlease also make sure everything's running true, and that the gear mesh is OK. I recall a video (some years ago) on youtube where a pilot (Matt Botos? Could be wrong ...) discussed the necessity to make sure everything is running as true, is balanced as good as possible, because it's not only affecting the electronics, but also at some point can shake everything else apart ...\r<br>\n\r<br>\nFrom Kyle Dahl I recall he said that the muffler and how it's attached to the engine also plays a major role, or can play, if it's resonance frequencies are adverse.\r<br>\n\r<br>\nOf course, if you move the wires, and if the NEO is not fixated properly, it will also move ever so slightly on it's pad, so the sensors and as a result the servos will react.\r<br>\n\r<br>\nKind regards\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":""}