{"ok":true,"content":"It is easy from my opinion.\r<br>\n\r<br>\nThe filter is a very precise and narrow notch filter which is supposed to filter sensor signal in the self-resonance frequency of the whole system. The only thing you have to set up is where this frequency is at the given heli. Once set up - you will be able to dial in more gain and also probably try another frequency for the servos with more gain.\r<br>\n\r<br>\nRaise your gain unless you notice some wobbly behaviour at the skids (aileron) in a steady hover to get it visible. Please do this in one bank only and be ready to switch banks if it shakes too much.\r<br>\n\r<br>\nTry to elaborate the range with the filter where it will be less\/gone. Mine was less\/gone between 11 and 15 Hz. So i took the middle which is 13 Hz and fits perfectly. Now i can raise the gains all up w\/o any issues!\r<br>\n\r<br>\nSidenote: If you will probably dial in 6 or 7 Hz you will also notice a decrease - but as it only cuts 50% of the peaks (half the frequency) you will only be able to raise the gain a bit - and the wobble will never be removed completely.\r<br>\n\r<br>\nThe frequency depends on the electrical reponsibility (Control loop, Servos) and mechanical behaviour (Stiffnes of the frame, Dampening of the head etc.). I'd start with 10Hz up to 20 Hz to try.<br>\n<br>\nregards (EN) \/ Gruss (DE) \r<br>\n\r<br>\nRainer Vetter\r<br>\n\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\nPosting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.\r<br>\n\r<br>\nF\u00fcr Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollst\u00e4ndig abarbeiten. Nehmt Euch Zeit, beantwortet R\u00fcckfragen in Ruhe und vollst\u00e4ndig.\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\n<i>F\u00fcr Einzelkommunikation bitte <strong>ausschlie\u00dflich Email<\/strong> verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.\r<br>\nFor single user communication please send a <strong>email only<\/strong>! PM, Messenger, Chat etc. won't be read.<\/i><br>\n<br>\n<br>\n<br>\n6 mal bearbeitet. Zuletzt am 16.05.2024 12:19 von RV.","note":""}