{"ok":true,"content":"Hello Siggi,<br><br> Regarding the instructions... some technical understanding and logical thinking are required, it says at the beginning of the instructions!<br> Much of it is only shown schematically \u2013 for example, the tail servo on page 9, picture 1, I hardly think you could install the servo in this position \u2013 it&#39;s only about the fact that the two levers must be at 90\u00b0 to each other.<br> If you use the correct screw for the chassis connection in every position, it will fit perfectly.<br> The screw for the spacer bracket is an M3x6, which is screwed directly into the small hole with the plastic spacer bushing without a locknut; the rubber plug, cut to the appropriate length, is placed on the screw head.<br> One more tip... attach the tail control rod last, first screw the threaded rods into the ball joints and loosely insert them into the CFRP tube, then temporarily press the whole thing into the ball joint at the front and back.<br> Important... turn both levers to a 90\u00b0 position so you can see how much thread is still visible or if you need to shorten the pipe a bit. (It should fit)<br> I hope these tips can help you a little further.<br><br> Best regards<br><br> Fritz","note":"machine-translated from German"}