{"ok":true,"content":"Hello,<br><br> I would like to share my experience with the Glogo.<br><br> I flew 110 flights with the Glogo before I sold it.<br><br> I powered the helicopter with a YS 120SRX motor, which I modified slightly to get more power. However, I deliberately didn&#39;t use one of my other YS 120SRX motors with its final tuning. Only the Goblin 700 Nitro Sport can handle that kind of power; there&#39;s no visible wear (and I&#39;m curious to see how the Diabolo Nitro will fare).<br><br> After I converted the Glogo to an aluminum rotor head, I was also satisfied with the agility.<br><br> Since the Glogo was never tested with Power 120 motors, the increased wear and tear probably did not occur.<br><br> I needed four clutch linings in 110 flights. The clutch apparently can&#39;t handle the high torque and tends to slip occasionally (regardless of engine speed). Goblin also had 110 flights and shows no visible wear on the lining.<br><br> The cross-connector for the rear support with the threaded rod is quite something... Well...<br> I replaced these with aluminum hood stays. The original threaded rod had stretched the carbon fiber...<br><br> However, anyone who operates a Glogo with a good 91 motor or at most a 105 motor should enjoy it for a very long time.<br><br> Conclusion:<br> The first 50 flights with the Glogo were a joy. The helicopter should be delivered with an aluminum rotor head from the factory.<br><br> I wish the new owner much enjoyment with the Glogo.<br><br><br><br> Edited twice. Last edited on 21.07.2019 at 16:49 by Sky.","note":"machine-translated from German"}