{"ok":true,"content":"Hello Reiner<br><br> Awesome! Works perfectly. I had to swap the values for &quot;Out Higher&quot; and &quot;Out Lower&quot; on cell 29 so that the landing gear would stay still in the retracted position. That was a great exercise to begin to understand what the system is capable of!<br><br> Off-topic. I have another question about the throttle \u2013 to start the turbine, I need three values. Currently, I&#39;ve solved this using the engine switch, bank by bank: off 0%, on 10%, full throttle 100%, and the ECU has been programmed accordingly. Why can I only set the idle speed bank by bank and not a general setting?<br><br> And one last question, after which I&#39;m going to fly the jet! :-) I&#39;ve set the timer to vibrate, beep, and speak. The interval is 30 seconds. But it&#39;s not doing any of that. After the time is up, the time display changes to &quot;backlit&quot; and keeps running. Have I set something up incorrectly?<br><br> Thank you so much for the great support! My next plane is the CARF Hawk. And then there&#39;s the J-10 with vector control. But that can wait :-)<br><br> Greeting<br> Martin","note":"machine-translated from German"}