{"ok":true,"content":"Good bye,<br> Attached is my plane\/macro cell setup for AddictionX - for this flight setting: Pos.\/Neg. flips over the lateral axis.<br> Aileron\/Elevator Expert mixer only in Bank 3 (3D settings) with the elevator almost fully pulled\/pushed. This only applies if activated via switch 2.<br> In the expert mixer, I have the flaps in CH2 set to 90 and CH3 to -90.<br> I flew several times today with these settings - it works.<br> In the macro cells I have the blinking message: Compiler loop!! What does that mean?<br> Best regards, Stefan<br><br><br><br> Edited once. Last edited on 03\/10\/2015 at 21:18 by Klemmring. File attachments:<br> <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?47,file=20034,filename=Addiction_X.zip\" target=\"_blank\" rel=\"noopener noreferrer\">Open<\/a> | <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?47,file=20034,filename=Addiction_X.zip,download=1\" target=\"_blank\" rel=\"noopener noreferrer\">Download<\/a> - Addiction_X.zip (447 bytes)<br> <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?47,file=20035,filename=Addiction_X.zip\" target=\"_blank\" rel=\"noopener noreferrer\">Open<\/a> | <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?47,file=20035,filename=Addiction_X.zip,download=1\" target=\"_blank\" rel=\"noopener noreferrer\">Download<\/a> - Addiction_X.zip (225 bytes)<br>\n                    \n                ","note":"machine-translated from German"}