{"ok":true,"content":"Hello,<br> Great, but not just Swabian.<br> One more thing: The AddictionX is a 3D aircraft; I want the model to perform the tightest possible flips (positive\/negative).<br> For this, I need to mix the ailerons and elevator. If I only want to do this using switch 2, I can manage it. In the expert mixer, mix in channels 1, 2, and 3 for the flaps. And in macro cell 9, select channel and switch 2.<br> Set the delay. (Landing flaps, thermal setting)<br> I&#39;d like it to work a little differently: Aileron\/elevator mixer only in bank 3 (3D settings) when the elevator is almost fully pulled\/pushed. This should only apply if activated via switch 2.<br> Best regards, Stefan","note":"machine-translated from German"}