{"ok":true,"content":"Hi,\r<br>\n\r<br>\nyes, it is.\r<br>\n\r<br>\nnot related to the tail, I found that you have high trim values on the swash plate. I recommend re-setting the servo arms on the splines of the respective servos, to be able to trim closer to zero.\r<br>\n\r<br>\nDo you have zero collective pitch (really-really) at center stick?\r<br>\n\r<br>\nPlease do a trim flight. This would mainly be to show if the servo centers\/trims are OK (especially on the tail it would be of interest).\r<br>\n\r<br>\nWhat I would try is dialing down I-Gain (Tail Expert) by 10 or 20, and compare, or increase P-Gain there (instead of decreasing I-Gain), and compare.\r<br>\nYou could also add a small amount of D-Gain, and compare.\r<br>\n\r<br>\nMake sure that you always have one bank with safe parameters, where you can switch to in case the tail starts to oscillate quickly or even violently, if the P and\/or D values were too high.\r<br>\n\r<br>\nKind regards\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":""}