{"ok":true,"content":"Good morning,<br><br> I am trying to fly my T-Rex with Wren44 using the Neo, the internal speed controller and Hall sensor with 1 active magnet on the clutch.<br><br> I&#39;ve had 3 engine shutdowns in flight so far and am still looking for the cause of the last 2.<br><br> I discarded the first one; the base throttle was at 0. I assume that the Neo controller then tried to reduce the throttle when the rotor was unloaded and therefore sent a throttle 0 signal... Turbine off... Autorotation, everything OK...<br><br> The entire setup was redone. The turbine ECU paths were re-bent.<br><br> The setup is as follows:<br> Safety switch OFF: Throttle 0<br> Safety switch ON, motor switch OFF, throttle 7% (idle)<br> Safety switch ON, motor switch ON, throttle 7% (idle): the turbine is already spinning at 20,000 RPM, even though the throttle value displayed on the GSU is NOT changing. Strange, but okay.<br><br> Safety switch ON, engine switch ON, direct throttle to start up in bank 1, then switch to bank 2, speed setpoint 1700 - that&#39;s fine.<br> Since I wanted to run the tail optimizer, I switched to bank 2, RPM 1900. Then a pirouette, stopped, bounced a bit, and turbine OFF. Autorotation... hmmm<br><br> Now I&#39;m searching... the ECU only logs every 5 seconds, so I can&#39;t really tell if the stabilizer shut down the turbine again... tail unloaded, RPMs rise, readjustment... is that possible? Can the Neo output throttle values below base throttle when the stabilizer is active? In my case, anything below 5% throttle results in a shutdown.<br><br> The only unusual entry in the log, shortly before the engine shuts down, is &quot;Signal missing from speed sensor&quot;.<br> I&#39;m attaching the log and setup from the Neo. I&#39;m currently a bit stumped.<br><br> Could my ECU be faulty, or is the Neo shutting down the engine? And I really don&#39;t want to fly with a throttle curve, but that would be the next attempt... troubleshooting in this weather isn&#39;t fun...<br><br> In dry runs the gas values are correct, but without active control, i.e. turbine off or helicopter without blades on the ground, it&#39;s all pointless, everything works fine.<br><br> Well... maybe I haven&#39;t understood the nitro regulator yet, or it&#39;s being disabled due to the missing RPM signal, or or or my ECU is faulty... I don&#39;t know what to do.<br><br> Greetings<br> Markus<br> | - neo-t-rex-wren.zip (538 bytes)<br>\n                    \n                ","note":"machine-translated from German"}