{"ok":true,"content":"\n\r<br>\nA 5.1 V regulator for the 8900 tail servo. Note, this servo doesn't like 6 V, not at all (some say it does but I'm not planning to find out the hard way). An Align DS 650 might be an alternative that can handle 6 V, but I haven't tried.\r<br>\n<hr>\r<br>\n\n\n\n\n\r<br>\nKontronik Jive 80 HV running the BEC at 6 V, using two supply wires to \"Rx B\" and \"Rx C\". \r<br>\nGovernor mode, flat 100 throttle curve, highest timing. Apparently, it's the most maingear-friendly setting. I have stripped loads of maingears with less-than-100 governor throttle curves - too much torque.\r<br>\n\r<br>\nWhat else... Neu 1907H\/1.5Y motor, Hyperion 3300 mAh 4s x 2 LiPos, 13 tooth pinion, Bando-labeled (!) upgrade belt (<i>highly<\/i> recommended!!), BBT\/Maniac 553 blades.<br>\n<br>\n<br>\n<br>\nEdited 6 time(s). Last edit at 11\/21\/2009 11:16PM by GravityKills.<br><br>","note":""}