Hallo,
Entschuldigung, dass ich diesen Thread gekapert habe :-)
Zwei Dinge fallen mir dabei ein:
Die in der von Ihnen geladenen Konfiguration enthaltenen Makrozellen bewirken, dass der VStabi diskrete Steuerkanäle (Servoausgänge) in einer bestimmten Reihenfolge ausgibt (1-2-3-4 Höhenruder-Querruder-Leitwerk-Neigung, wenn es so wäre, nur ein Beispiel), über S.BUS.
Wenn die Kanalreihenfolge bei einer anderen Version (Hardware oder Software) der nachfolgenden Flugsteuerung unterschiedlich ist, ist die Steuerungsreaktion zufällig (z. B. steuert das Höhenruder den Schubhebel, das Querruder steuert das Heck usw.).
VStabi gibt das ursprüngliche S.BUS-Signal aus, nicht S.BUS2. Wenn die nachfolgende Flugsteuerung eine andere S.BUS-Implementierung hätte, könnte dies ebenfalls zu Fehlfunktionen führen.
Zweitens berichtete ein Kunde von einem ähnlichen Fall und änderte den digitalen Ausgang des VStabi auf Spektrum, der mit dem Spektrum-Eingang des anderen Flugcontrollers verbunden ist.
Auf diese Weise hatte er zwar die Kontrolle, aber die Steuerungselemente waren vertauscht (z. B. war das Querruder das Höhenruder und umgekehrt).
Dies kann in den Makrozellen behoben werden, indem Sie dort den anderen Eingang auswählen (z. B. MC11, wenn ich mich richtig erinnere, hat den Eingang FC Ail, ändern Sie ihn in FC Elev).
Bitte beachten Sie, dass der Spektrum-Anschluss mit 3,3 V betrieben wird.
Der VStabi kann damit funktionieren, _aber_ Sie dürfen keine zusätzliche RC-Leistung daran anschließen, da dies in einer Endlosschleife die nachfolgende Flugsteuerung beschädigen würde.
Kind regards
Eddi
Born to fly ...
forced to work.
Hi,
sorry for napping this thread :-)
Two things which come to mind:
Macrocells in the Setup you load make the VBar output discrete control channels (servo outputs) in a certain order (1-2-3-4 elevator-aileron-tail-pitch if it was that way, just an example), via S.BUS.
If the channel order is different, on a different version (hardware or software) of the subsequent flight control, the control response will be random (like, elevator drives throttle, aileron drives tail etc.).
VBar outputs the original genuine S.BUS signal, not S.BUS2, so if the subsequent flight control would have a different S.BUS implementation, this could be a reason for malfunction, too.
The second thing is, a customer reported something similar and changed the digital output on the VBar to Spektrum, connected to the Spektrum input on the other flight control.
This way, he had control, but with mixed up channels (e.g. aileron was elevator and the other way around).
This can be fixed in the Macrocells, if you there select the other input (like, MC11 if I recall correctly, has input FC Ail, change to FC Elev).
Please mind that the Spektrum connection runs on 3.3 V.
The VBar can work with that, _but_ you must not connect extra r/c power to it, then, else that would, in a loop, fry the subsequent flight control.
Kind regards
Eddi
Born to fly ...
forced to work.